Hcalory T2: Cordless Pressure Washer with a Claimed 2500 PSI

The Hcalory T2 is a cordless pressure washer with a 160 W brushless motor. Its stated maximum pressure is 2500 PSI, or approximately 172 bar, and its stated flow rate is 2.5 US gallons per minute (GPM), approximately 9.5 litres per minute. It can draw water from a tap, garden hose or bucket, so it does not always need to be connected to a mains water supply.

Motor, pressure and flow rate

The washer uses a brushless DC motor. Unlike a brushed motor, it has no carbon brushes that wear out and require replacement. Battery power also lets you work without a connection to an electrical socket.

It is important to distinguish the stated pressure and flow figures from performance in actual use. The conditions under which the figures were measured are not known. If the washer delivered 172 bar and 9.5 litres per minute at the same time, its hydraulic output would be approximately 2.7 kW—far more than the stated 160 W motor rating. The figures therefore cannot be treated as simultaneous operating pressure and flow without further verification.

Flow rate also matters when drawing water from a container. At 9.5 litres per minute, a 10-litre bucket would empty in about a minute; actual consumption depends on the conditions of use.

Six nozzle settings

The supplied nozzle set offers six settings, including spray angles from 0° to 40°, as well as jet and shower modes. A narrower jet concentrates water on a smaller area, while a wider spray is useful for rinsing larger surfaces.

A narrow jet may help remove stubborn dirt, but it can damage delicate surfaces. When washing a car or another sensitive surface, start with a wider spray from farther away and test the effect on an inconspicuous area first. Never direct the water jet at people or animals.

Batteries and accessories

The package includes two 21 V lithium batteries, each with a capacity of 4.0 Ah. When one runs out, you can switch to the other, although changing batteries briefly interrupts the work. Runtime and charging time are not specified.

Alongside the washer and nozzles, the package includes a foam attachment, charger, water filter, shut-off valve and adapters. The foam attachment allows cleaning with detergent. The filter helps catch debris in the incoming water, particularly when drawing from a bucket, but it does not guarantee protection against damage.

Where to use the washer

The Hcalory T2 can be used for cleaning in the garden or workshop, or for washing a car. Depending on the available water source, it can connect to a tap or garden hose, or draw from a bucket. The bucket option is useful where there is no water supply nearby, although the amount of water prepared limits working time.

When drawing from a container, keep the water intake submerged so the washer does not draw in air. If the water contains debris, pay attention to the filter. Before connecting the washer, check the manual for supply-hose and adapter requirements; their exact dimensions and the limits on drawing water are not specified in the available information.