3 min read
Cybertake S2 Pro: Portable Air Conditioner with a Panasonic Inverter Compressor
The Cybertake S2 Pro is a portable air conditioner with a cooling capacity of 5,100 BTU/h and a heating capacity of 6,100 BTU/h. It uses a Panasonic inverter compressor and is designed for smaller spaces, such as a tent, caravan, workshop or small room.
The Cybertake S2 Pro is a portable air conditioner with a cooling capacity of 5,100 BTU/h and a heating capacity of 6,100 BTU/h. It uses a Panasonic inverter compressor and is designed for smaller spaces, such as a tent, caravan, workshop or small room. Its short adapter cable and the adapter’s limited protection against moisture are important considerations when planning where to use it.
Cooling and heating in one device
The cooling capacity of 5,100 BTU/h is equivalent to approximately 1,500 W, while the heating capacity of 6,100 BTU/h is approximately 1,800 W. These figures describe cooling and heating output, not the device’s electrical input power.
The two modes allow the air conditioner to provide cooling or supplementary heating as needed. The results depend on the space and conditions, including its size and insulation. The stated capacity alone does not guarantee the same level of comfort in a tent as in a room.
Inverter compressor and power supply
The S2 Pro uses a Panasonic inverter compressor and a 48 V DC power supply. The inverter allows the compressor’s output to be adjusted more smoothly, rather than repeatedly switching it off and restarting it to regulate performance. An intelligent algorithm supplements the control system.
This type of regulation may help with efficiency and operating noise. However, without specific power consumption and noise figures, it is not possible to say how much electricity the unit will use or how quiet it will be, for example, while someone is sleeping. The 48 V DC rating alone also does not mean the air conditioner can be connected to any battery power source.
Short cable and adapter protection
The power adapter has a short cable, which may limit where the air conditioner can be placed in relation to the available power source. Adapter overheating has also been reported, but without further details about the operating conditions, the extent of the issue cannot be assessed. If the adapter becomes unusually hot, switch off the device, disconnect it from the power supply and follow the manufacturer’s instructions.
The difference in protection ratings is also important: the unit itself is rated IPX4, meaning it is protected against splashing water, while the adapter is rated IP20 and is not protected against water. The air conditioner’s water protection therefore does not extend to the adapter. When using it in a tent or outdoors, keep the adapter protected from rain and moisture.
Where the S2 Pro may be useful
The portable design allows the unit to be moved between smaller spaces. It may provide cooling or heating in a caravan or tent, or supplement existing heating or cooling in a workshop or small room.
Before setting it up, check the manufacturer’s instructions for installation, heat exhaust and condensate handling requirements. Exact dimensions, weight, electrical input power and noise levels are not included in the available information, although they are important when choosing the device and planning its power supply.